Litter-Robot Connect: I just installed my Connect Upgrade Kit and now I get 3 flashing lights
Re-open the control panel bezel and check that the Hall Effect Sensor position is correct. Also, check that the wiring is correct. The yellow wire is on the left and the orange wire is on the right. They must be closest to the center, as well (as pictured). Its best to have a small piece of tape on top to secure, so if you have removed this for some reason, add a new piece of tape. Do not tape over the ends of the sensors, but you can wrap it down over the sides and rear of the stand. Waterproof tape is best. Also make sure you have put the tape over the wiring channel back in place or replaced with a new piece, to keep wires away from the black gear wheel.